Master's Degree in Engineering & Technology in Karlskrona in Sweden

Compare Masters Programs in Engineering & Technology 2017 in Karlskrona in Sweden

Engineering & Technology

In order to successfully obtain a Masters qualification, you will need to obtain a number of credits by passing individual modules. Most taught Masters will have a number of core modules which you must take and pass in order to obtain the qualification. The assessment of research Masters is almost always entirely by a single dissertation module or project.

Studies in engineering and technology prepare you for the technologically oriented workforce of today.

Members of the workforce with engineering and technology training are sought out by many industries including medical research and computer software development.

 

Sweden (Sverige) is the largest of the Nordic countries, with a population of about 9.5 million. It borders Norway and Finland and is connected to Denmark via the bridge of Öresund (Öresundsbron). Sweden has a strong tradition of being an open, yet discreet country.

Karlskrona city is home to Sweden’s naval base. It is located in the Blekinge County. Karlskrona has over 30,000 residents. It is home to the Blekinge Institute of Technology.

Request Information Master's Degrees in Engineering & Technology in Karlskrona in Sweden 2017

Read More

Master’s Programme in Mechanical Engineering with Emphasis on Structural Engineering

Blekinge Institute of Technology
Campus Full time 2 years August 2017 Sweden Karlskrona

The aim of the program is to have the student prepare for participation in advanced product development or research within mechanical engineering. The aim is that the student after completed degree should master a coordinated working method at analysis for... [+]

Masters in Engineering & Technology in Karlskrona in Sweden. Master’s Programme in Mechanical Engineering with Emphasis on Structural Engineering The aim of the program is to have the student prepare for participation in advanced product development or research within mechanical engineering. The aim is that the student after completed degree should master a coordinated working method at analysis for decision support in the product development process, the extensive modules of virtual and physical modelling, simulation and experimental investigation and optimisation. Coordinated working method at analysis for decision support. The student is expected to inform herself/himself about current field-relevant research and considerably increase her/his ability to communicate her/his own contributions with scientific facts and relations both orally and in writing by means of modern tools for visualisation and documentation. The coordinated working method can in short be described according to: Virtual models for description of interesting product properties and behaviours are developed, verified and used for simulations of the functionality of the system. The Simulation result is compared with experimental results of studies on delimited parallelly developed physical models, or with experiences from earlier development, with the aim of validating the virtual models. The coordination also implies that the virtual models are used to design good physical models and measurement strategies. This process is repeated until sufficient agreement is achieved. Simulation with the virtual model can then be used for optimisation. If the optimisation shows a need for changes that influence the relevance for the current model, the whole procedure is... [-]